Audio-Technica AT-OC9XEN

€369.00

Dual moving coil stereo cartridge with Elliptical nude stylus.

Quantity:
Add to basket

Dual moving coil stereo cartridge with Elliptical nude stylus.

Dual moving coil stereo cartridge with Elliptical nude stylus.

The Next Generation of the Legendary OC9 Cartridge Series

Since its introduction more than 30 years ago, Audio-Technica’s pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction. Featuring a square shank for accurate stylus alignment and nude diamond for increased fine detail retrieval.

  • Features low mass nude elliptical stylus and aluminium cantilever

  • A neodymium magnet and pure iron yoke provide increased magnetic energy

  • Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws – no nuts required 

  • Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction

  • Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve the purest signal possible

Elliptical Nude Stylus

Elliptical diamond stylus follows the groove modulation with greater precision compared to a conical stylus, offering improved frequency and phase responses whilst reducing distortion.

Easy Mounting

Threaded holes in the cartridge body enable the cartridge to be mounted on to the headshell, or integral tonearm, with just two screws M2.6 – no nuts or bolts required.

Aluminium Body

Aluminum body minimizes unwanted vibration for reduced resonance and superior audio reproduction

Made in Japan

Produced in the Audio-Technica Fukui factory in Japan under strict quality control for precise manufacturing.

Walden High-End Audio-Technica
    • Frequency Response: 20 - 30,000 Hz

    • Channel Separation: 25 dB (1 kHz)

    • Vertical Tracking Angle: 20 degrees

    • Vertical Tracking Force: 1.8 to 2.2 g (standard 2.0 g)

    • Stylus Construction: Nude square shank

    • Recommended Load Impedance: Min 100 Ohms

    • Coil Impedance: 12 Ohms (1 kHz)

    • DC Resistance: 12 Ohms

    • Coil Inductance: 25 μH (1 kHz)

    • Output Voltage: 0.35 mV (@ 1 kHz, 5 cm/sec)

    • Output Channel Balance: 1.5 dB (1 kHz)

    • Stylus Shape: Elliptical Nude

    • Cantilever: Aluminium pipe

    • Static Compliance: 20 x 10 – 6 cm / dyne

    • Dynamic Compliance: 9 x 10 – 6 cm / dyne (100 Hz)

    • Mounting: 1/2” centers / Threaded inserts

    • Cartridge Weight: 7.6 g

    • Dimensions: 17.3 (H) x 16.8 (W) x 25.7 (L) mm

    • Accessories Included: 1 non magnetic screw driver1 brush2 washers4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm1 plastic protector

    • Body Material: Aluminium

    • Model: AT-OC9XEN

    • Stylus Size: 0.3 x 0.7 mil

    • Terminal Pins: Brass

    • Wire Used for Coil: PCOCC (Copper by Ohno Continuous Casting process.)